Users Guide

5–Fibre Channel Noninteractive Commands
-ctp (CT Ping Test)
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 35 Copyright © 2021 Marvell
Where:
<hba instance>
=
Adapter number (use the -g command to find)
<hba wwpn>
=
World wide port name of the adapter
<target wwpn>
=
World wide port name of the target
<param name>
=
One of the following parameter names:
 TestCount
 TestIncrement
 OnError
<param alias>
=
One of the following parameter aliases:
 TC
 TI
 OE
<param value>
=
Value of parameter or alias (see Tab le 5- 3 )
Table 5-3. Ping Diagnostics Parameters
Parameter
Name
Parameter
Alias
Parameter
Values
Description
TestCount TC 0–10,000 0 specifies that the -fcp command (see
-fcp (Ping Test) continues until the user interrupts
it.
1 to 10,000 specifies that the -fcp command
(see -fcp (Ping Test) stops after sending count
pings.
TestIncrement TI 1–10,000 Specifies the quantity of the test increment, which
must be less than the quantity of the test count.
OnError OE 0–2 = Ignore on
error
1 = Stop on error
2 = Loop on error
Specifies how errors are handled during any spe-
cific pass:
 Ignore on error indicates that errors are
ignored and the test sequence continues
 Stop on error indicates that the test sequence
halts when an error is encountered
 Loop on error indicates that the test uses the
same data pattern and test when errors are
encountered