Users Guide

5–Fibre Channel Noninteractive Commands
-a
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 29 Copyright © 2021 Marvell
 -g
 -gs (Configure Parameters [Monitoring])
 -h (Help)
 -ha (Adapter Alias [FCoE Configuration])
 -i (FC Adapter Information; FC VPD Information; FC VFC Information)
 -kl (Loopback Test)
 -kr (Read Write Buffer Test)
 -l (FC Target/LUN Information)
 -ls (Display Parameters [HBA Statistics]; Link Status)
 -m (Selective LUNs)
 -mbiv (Flash/MBI Information)
 -n (Configure HBA Parameters)
 -o (Redirect Standard Output To a File)
 -p (Target Persistent Bindings)
 -pa (Adapter Port Alias [FCoE Configuration])
 -pc (Adapter Personality Change)
 -pl (Persistent Names [udev] – Linux only)
 -q (Target Link Speed [iiDMA])
 -qos (Quality of Service [QoS])
 -r (Parameters Update; Save HBA Parameters)
 -rdp (Read Diagnostics Parameter)
 -s (Suppress Output [Silent Mode])
 -scm (Congestion Management)
 -sp (FC Board Config Update)
 -t (FC Target/LUN Information)
 -tb (Target Beacon)
 -tm (Temperature Monitor)
 -tp (Topology)
 -trace (FCE Trace)
 -u (Firmware Preload Table Update)
 -v (QCC CLI Version Information)
 -vp (Virtual Ports [NPIV])
 -x (XML Output [Legacy])
 -x2 (XML Output)
 -z (All Information)
-a
Use the -a command to view or change the state (ON or OFF) of an LED
beacon.
NOTE
 The adapter must not be in silent mode. See “-s (Suppress Output
[Silent Mode])” on page 87 to issue a response to this command.