Users Guide

5–Fibre Channel Noninteractive Commands
Host Port Configuration
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 26 Copyright © 2021 Marvell
To show the information for all adapters, issue the following command:
qaucli -pr fc -z all
Host Port Configuration
Use these options to show the information for one or all of the adapter ports in the
system. The -z option shows the combination of the commands listed in
Table 5-1. The commands are listed in alphabetical order.
.
Command Format
The command format for noninteractive mode is:
qaucli -pr fc -<command> <hba instance>|<hba wwpn> view|info
Where:
Table 5-1. Options Shown by -z
CLI Description See User’s Guide Section
-c Show adapter settings “-c (Display HBA Parameters)” on page 34
–dm
Show general or detailed
digital diagnostic monitor-
ing
“-dm (Transceiver Diagnostics Monitoring Interface [DMI])” on
page 36
-e Configure boot device “-e (Boot Devices Configuration)” on page 39
-fg View driver settings “-fg (Display Driver Persistent Binding Settings)” on page 47
-gs Show adapter statistics “-gs (Configure Parameters [Monitoring])” on page 51
-i Show adapter information “-i (FC Adapter Information; FC VPD Information; FC VFC
Information)” on page 53
-l Show LUN list “-l (FC Target/LUN Information)” on page 65
-m Configure selective LUNs “-m (Selective LUNs)” on page 67
-p Configure target persistent
binding
“-p (Target Persistent Bindings)” on page 74
-t Show target list “-t (FC Target/LUN Information)” on page 89
<command> = One of the commands listed in “Command Summary” on
page 28
<hba instance> = Adapter port instance (use the -g command to find)
<hba wwpn> = Adapter world wide port name