Users Guide

5–Fibre Channel Noninteractive Commands
Host Configuration (Command Line Option -z)
Doc. No. TD-000947 Rev. 1
Janurary 29, 2021 Page 25 Copyright © 2021 Marvell
 List of adapters: adapter model, port number, worldwide port name
(WWPN), serial number (SN), adapter number (adapter 0–n), and status
(online or offline). Depending on the model, adapter information may also
include the instance number, link status (up or down), diagnostic mode
(D_Port), and SFP detection (installed or not).
 Total number of Marvell QLogic Fibre Channel Adapters detected
Host Configuration
(Command Line Option -z)
The command line option -z provides a summary for the selected adapter in a
single command. The command format is:
qaucli -pr fc -z
QConvergeConsole CLI shows the information in “Host Information (Command
Line Option -g)” on page 24, as well as the following additional information:
 Adapter general information
 Adapter Flash component version
 Adapter vital product data (VPD)
 Adapter parameter settings
 Driver settings information:
 Group: persistent
 Group: binding
 Device and LUN information
 Selective LUNs information
 Boot device settings
 SFP information
To show the information for a single adapter, issue the following command:
qaucli -pr fc -z <hba instance>|<hba wwpn>
Where:
NOTE
The failover and SAN device management APIs are Marvell-specific
libraries required for QConvergeConsole CLI. The versions of these libraries
are useful for debugging purposes.
<hba instance> = Adapter number (use the -g command to find)
<hba wwpn> = World wide port name of the adapter