Users Guide

7–Linux Driver Software
Driver Messages
51 BC0054508-00 J
bnx2i Driver Messages
The bnx2i driver messages include the following.
BNX2I Driver Sign-on
QLogic BCM57xx and BCM57xxx iSCSI Driver bnx2i v2.1.1D (May 12,
2015)
Network Port to iSCSI Transport Name Binding
bnx2i: netif=eth2, iscsi=bcm570x-050000
bnx2i: netif=eth1, iscsi=bcm570x-030c00
Driver Completes Handshake with iSCSI Offload-enabled C-NIC Device
bnx2i [05:00.00]: ISCSI_INIT passed
Driver Detects iSCSI Offload Is Not Enabled on the C-NIC Device
bnx2i: iSCSI not supported, dev=eth3
bnx2i: bnx2i: LOM is not enabled to offload iSCSI connections,
dev=eth0
bnx2i: dev eth0 does not support iSCSI
Exceeds Maximum Allowed iSCSI Connection Offload Limit
bnx2i: alloc_ep: unable to allocate iscsi cid
bnx2i: unable to allocate iSCSI context resources
Network Route to Target Node and Transport Name Binding Are Two Different
Devices
bnx2i: conn bind, ep=0x... ($ROUTE_HBA) does not belong to hba
$USER_CHOSEN_HBA
Where ROUTE_HBA is the net device on which the connection was offloaded
based on route information, and USER_CHOSEN_HBA is the Host Bus Adapter to
which the target node is bound (using iSCSI transport name)
Target Cannot Be Reached on Any of the C-NIC Devices
bnx2i: check route, cannot connect using cnic
NOTE
This message is displayed only when the user attempts to make an iSCSI
connection.