Users Guide

6–Boot Agent Driver Software
Setting Up MBA in a Client Environment
26 BC0054508-00 J
Setting Up MBA in a Client Environment
Setting up MBA in a client environment involves the following steps:
1. Configuring the MBA Driver.
2. Setting Up the BIOS for the boot order.
Configuring the MBA Driver
This section pertains to configuring the MBA driver on add-in NIC models of the
QLogic network adapter. For configuring the MBA driver on LOM models of the
QLogic network adapter, check your system documentation.
NOTE
You can use QLogic’s Comprehensive Configuration Management (CCM)
utility or the unified extensible firmware interface (UEFI) to configure the
MBA driver one adapter at a time as described in the following procedure.
CCM is available only when the system is in legacy mode; it is not available
in UEFI boot mode. The UEFI device configuration pages are available in
both modes.