Users Guide

14–Fibre Channel Over Ethernet
FCoE Boot from SAN
228 BC0054508-00 J
9. Confirm all FCoE visible disks are visible on the Multipath Devices or Other
SAN Devices pages (Figure 14-28).
Figure 14-28. Confirming FCoE Disks
10. Click Next to proceed.
11. Click Next and complete installation as usual.
Upon completion of installation, the system reboots.
12. When booted, ensure all boot path devices are set to start on boot. Set
onboot=yes under each network interface config file in
/etc/sysconfig/network-scripts.
13. On RHEL 6.4 only, edit /boot/grub/menu.lst as follows:
a. Delete all fcoe=<INTERFACE>:nodcb parameters from the
kernel /vmlinuz … line. There must be as many fcoe=
parameters as there were FCoE interfaces configured during
installation.
b. Insert fcoe=edd:nodcb to the kernel /vmlinuz … line.
RHEL 7 Installation
To install Linux FCoE boot on RHEL 7:
1. Boot from the installation medium.
2. On the installation splash screen, press the TAB key.