Users Guide

14–Fibre Channel Over Ethernet
FCoE Boot from SAN
213 BC0054508-00 J
Windows Server 2008 R2 and Windows Server 2008 SP2 FCoE
Boot Installation
To install Windows Server 2008 boot:
1. Before starting the OS installer, ensure that no USB flash drive is attached.
The EVBD and BXFCOE drivers must be loaded during installation.
2. Go through the usual procedures for OS installation.
3. When no disk devices are found, Windows prompts you to load additional
drivers.
4. Connect a USB flash drive containing the full contents of the provided EVBD
and OFC boot driver folders.
After all appropriate drivers are loaded, the setup show the target disks.
5. Before selecting the disk for installation, disconnect the USB flash drive.
To install Windows Server 2008 SP2 FCoE boot:
1. Load the EVBD driver (Figure 14-11).
Figure 14-11. Installing EVBD Driver