Users Guide

14–Fibre Channel Over Ethernet
FCoE Boot from SAN
205 BC0054508-00 J
3. Ensure that DCB and DCBX are enabled on the device (Figure 14-3). FCoE
boot is only supported on DCBX-capable configurations. As such, DCB and
DCBX must be enabled, and the directly attached link peer must also be
DCBX-capable with parameters that allow for full DCBX synchronization.
Figure 14-3. CCM Device Hardware Configuration
4. On some platforms, you may need to set the boot protocol through system
BIOS configuration in the integrated devices pane as described in the
preceding.