Users Guide

14–Fibre Channel Over Ethernet
FCoE Boot from SAN
204 BC0054508-00 J
Preparing QLogic Multiple Boot Agent for FCoE Boot (CCM)
CCM is available only when the system is set to legacy boot mode; it is not
available when the systems is set to UEFI boot mode. The UEFI device
configuration pages are available in both modes.
1. Invoke the CCM utility during POST. At the QLogic Ethernet Boot Agent
banner (Figure 14-1), press the CTRL+S keys.
Figure 14-1. Invoking the CCM Utility
2. From the Device List (Figure 14-2), select the device through which boot is
to be configured.
Figure 14-2. CCM Device List
NOTE
When running in NIC partitioning (NPAR) mode, FCoE boot is
supported only when the first function of the booting port is assigned
the FCoE personality. FCoE boot is not supported when the FCoE
personality is assigned to any other function.