Users Guide

12–NIC Partitioning and Bandwidth Management
Configuring for NIC Partitioning
188 BC0054508-00 J
3. Change the Multi-Function Mode to NPAR.
4. Configure the NIC parameters for your configuration based on the options
shown in Table 12-1, which lists the configuration parameters available on
the NIC Partitioning Configuration window.
Table 12-1. Configuration Options
Parameter Description Options
Flow Control Configures the Flow Control mode for this port.
 Auto
 TX Flow Control
 RX Flow Control
 TX/RX Flow Control
 None
PF#0, PF#2, PF#4,
PF#6
Displays the physical function (PF) information
regarding the partition(s) on port 0. Select to config-
ure.
See Table 12-2 for con-
figuration options.
PF#1, PF#3, PF#5,
PF#7
Displays the physical function (PF) information
regarding the partition(s) on port 1. Select to config-
ure.
See Table 12-2 for con-
figuration options.
Reset Configuration to
Default
Resets the NIC partition configuration to the factory
default settings.
—