Users Guide

11–QLogic Teaming Services
Event Log Messages
179 BC0054508-00 J
6 Informational Network controller
configured for 10Mb
half-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
7 Informational Network controller
configured for 10Mb
full-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
8 Informational Network controller
configured for
100Mb half-duplex
link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
9 Informational Network controller
configured for
100Mb full-duplex
link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
10 Informational Network controller
configured for 1Gb
half-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
11 Informational Network controller
configured for 1Gb
full-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
12 Informational Network controller
configured for 2.5Gb
full-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
13 Error Medium not sup-
ported.
The operating system
does not support the
IEEE 802.3 medium.
Reboot the operating
system, run a virus
check, run a disk check
(chkdsk), and reinstall
the operating system.
14 Error Unable to register
the interrupt service
routine.
The device driver can-
not install the interrupt
handler.
Reboot the operating
system; remove other
device drivers that may
be sharing the same
IRQ.
Table 11-8. Base Driver Event Log Messages (Continued)
Message
Number
Severity Message Cause Corrective Action