Users Guide

3–Adapter Management Applications
Windows Management Applications
73 CU0354602-00 M
To view port information:
qaucli -nic -pinfo [cna_port_inst]
Changing Adapter Properties
To configure the adapter port, issue the following command:
qaucli -nic -n [cna_port_inst] <config_name|config_alias>
<value> [<config_name|config_alias> <value>]
You can set the following properties:
 Port_Alias
 Port_Physical_MAC_Alias
 Port_LAA_MAC_Alias
You can change the variables listed in Table 3-1; however, some variables cannot
be changed on specific OSs or configuration states. To determine which ones can
be changed, use the -c keyword.
NOTE
For an adapter that is teamed or an adapter with VLANs, do not directly modify the
adapter properties. To ensure that the properties of all teamed adapters and adapters
with VLANs remain synchronized with the team properties, make property changes
only on the Team Management page (see
“Modifying a Team” on page 86 ).
Table 3-1. Port Adapter Variables and Values
Variable Values
Checksum_Offload_Enable on, off
IPv4_Checksum_Offload_Enable off, Rx, Tx, RxTx
IPv4_TCP_Checksum_Offload_Enable off, Rx, Tx, RxTx
IPv6_TCP_Checksum_Offload_Enable off, Rx, Tx, RxTx
IPv4_UDP_Checksum_Offload_Enable off, Rx, Tx, RxTx
IPv6_UDP_Checksum_Offload_Enable off, Rx, Tx, RxTx
Large_Send_Offload_Enable on, off
IPv4_Large_Send_Offload_v1_Enable on, off
IPv4_Large_Send_Offload_v2_Enable on, off
IPv6_Large_Send_Offload_v2_Enable on, off
Receive_Side_Scaling_Enable on, off