Users Guide

9–Windows Server 2016
Déploiement et gestion de Nano Server
150 BC0154503-02 F
Dans l'exemple précédent, C:\Nano\Drivers est le chemin d'accès des
pilotes QLogic. Cette commande met environ 10 à 15 minutes pour créer un
fichier VHD. Voici un exemple de sortie de cette commande :
Windows(R) Image to Virtual Hard Disk Converter for Windows(R) 10
Copyright (C) Microsoft Corporation. All rights reserved.
Version 10.0.14300.1000.amd64fre.rs1_release_svc.160324-1723
INFO : Looking for the requested Windows image in the WIM file
INFO : Image 1 selected (ServerDatacenterNano)...
INFO : Creating sparse disk...
INFO : Mounting VHD...
INFO : Initializing disk...
INFO : Creating single partition...
INFO : Formatting windows volume...
INFO : Windows path (I:) has been assigned.
INFO : System volume location: I:
INFO : Applying image to VHD. This could take a while...
INFO : Image was applied successfully.
INFO : Making image bootable...
INFO : Fixing the Device ID in the BCD store on VHD...
INFO : Drive is bootable. Cleaning up...
INFO : Dismounting VHD...
INFO : Closing Windows image...
INFO : Done.
Done. The log is at:
C:\Users\ADMINI~1\AppData\Local\Temp\2\NanoServerImageGenerator.log
8. Connectez-vous en tant qu'administrateur sur le serveur physique sur lequel
vous souhaitez exécuter le VHD Nano Server.
9. Pour copier le VHD sur le serveur physique et le configurer pour démarrer à
partir du nouveau VHD :
a. Accédez à Gestion de l'ordinateur > Stockage > Gestion des
disques.
b. Cliquez avec le bouton droit sur Gestion des disques et sélectionnez
Attacher un disque dur virtuel.
c. Indiquez le chemin d'accès au fichier du VHD
d. Cliquez sur OK.
e. Exécutez
bcdboot d:\windows.