Users Guide

6–Boot from SAN Configuration
iSCSI Boot from SAN
75 AH0054602-00 M
3. On the iSCSI General Parameters page (Figure 6-7), press the DOWN
ARROW key to select a parameter, and then press the ENTER key to input
the following values (Table 6-2 on page 76 provides descriptions of these
parameters):
 TCP/IP Parameters via DHCP: Disabled
 iSCSI Parameters via DHCP: Disabled
 CHAP Authentication: As required
 IP Version: As required (IPv4 or IPv6)
 CHAP Mutual Authentication: As required
 DHCP Vendor ID: Not applicable for static configuration
 HBA Boot Mode: As required
 Virtual LAN ID: Default value or as required
 Virtual LAN Mode: As required
Figure 6-7. System Setup: iSCSI General Parameters