Users Guide

6–Boot from SAN Configuration
iSCSI Boot from SAN
71 AH0054602-00 M
Enabling NPAR and the iSCSI HBA
To enable NPAR and the iSCSI HBA:
1. In the System Setup, Device Settings, select the QLogic device (Figure 6-2).
Refer to the OEM user guide on accessing the PCI device configuration
menu.
Figure 6-2. System Setup: Device Settings
2. Enable NPAR.
Configuring the Storage Target
Configuring the storage target varies by target vendors. For information on
configuring the storage target, refer to the documentation provided by the vendor.
To configure the storage target:
1. Select the appropriate procedure based on your storage target, either:
 Create an storage target using software such as SANBlaze
®
or
Linux-IO (LIO
™
) Target.
 Create a vdisk or volume using a target array such as EqualLogic
®
or
EMC
®
.