Users Guide

5–Adapter Preboot Configuration
Getting Started
46 AH0054602-00 M
The Main Configuration Page (Figure 5-3) presents the adapter
management options where you can set the partitioning mode.
Figure 5-3. Main Configuration Page
4. Under Device Level Configuration, set the Partitioning Mode to NPAR to
add the NIC Partitioning Configuration option to the Main Configuration
Page, as shown in Figure 5-4.
Figure 5-4. Main Configuration Page, Setting Partitioning Mode to NPAR
In Figure 5-3 and Figure 5-4, the Main Configuration Page shows the following:
 Firmware Image Properties (see “Displaying Firmware Image Properties”
on page 48)
NOTE
NPAR is not available on ports with a maximum speed of 1G.