Users Guide

8–iWARP Configuration
Configuring iWARP on Windows
181 AH0054602-00 M
If iWARP traffic is running, counters appear as shown in the Figure 8-4
example.
Figure 8-4. Perfmon: Verifying iWARP Traffic
4. To verify the SMB connection:
a. At a command prompt, issue the
net use command as follows:
C:\Users\Administrator> net use
New connections will be remembered.
Status Local Remote Network
---------------------------------------------------------
OK F: \\192.168.10.10\Share1 Microsoft Windows Network
The command completed successfully.
b. Issue the netstat -xan command as follows, where Share1 is
mapped as an SMB share:
C:\Users\Administrator> netstat -xan
Active NetworkDirect Connections, Listeners, ShareEndpoints
Mode IfIndex Type Local Address Foreign Address PID
Kernel 56 Connection 192.168.11.20:16159 192.168.11.10:445 0
Kernel 56 Connection 192.168.11.20:15903 192.168.11.10:445 0
Kernel 56 Connection 192.168.11.20:16159 192.168.11.10:445 0
NOTE
.
For more information on how to view Marvell RDMA counters in
Windows, see “Viewing RDMA Counters” on page 136.