Users Guide

8–iWARP Configuration
Configuring iWARP on Windows
179 AH0054602-00 M
2. Using Windows PowerShell, verify that RDMA is enabled. The
Get-NetAdapterRdma command output (Figure 8-1) shows the adapters
that support RDMA.
Figure 8-1. Windows PowerShell Command: Get-NetAdapterRdma
3. Using Windows PowerShell, verify that NetworkDirect is enabled. The
Get-NetOffloadGlobalSetting
command output (Figure 8-2) shows
NetworkDirect
as Enabled.
Figure 8-2. Windows PowerShell Command: Get-NetOffloadGlobalSetting
To verify iWARP traffic:
1. Map SMB drives and run iWARP traffic.
2. Launch Performance Monitor (Perfmon).
3. In the Add Counters dialog box, click RDMA Activity, and then select the
adapter instances.