Users Guide

8–iWARP Configuration
Configuring iWARP on Windows
178 AH0054602-00 M
6. In the Warning - Saving Changes message box, click Yes to save the
configuration.
7. In the Success - Saving Changes message box, click OK.
8. Repeat Step 2 through Step 7 to configure the NIC and iWARP for the other
ports.
9. To complete adapter preparation of both ports:
a. On the Device Settings page, click Finish.
b. On the main menu, click Finish.
c. Exit to reboot the system.
Proceed to “Configuring iWARP on Windows” on page 178 or “Configuring iWARP
on Linux” on page 182.
Configuring iWARP on Windows
This section provides procedures for enabling iWARP, verifying RDMA, and
verifying iWARP traffic on Windows. For a list of OSs that support iWARP, see
Table 7-1 on page 127.
To enable iWARP on the Windows host and verify RDMA:
1. Enable iWARP on the Windows host.
a. Open the Windows Device Manager, and then open the 41xxx Series
Adapter NDIS Miniport Properties.
b. On the FastLinQ Adapter properties, click the Advanced tab.
c. On the Advanced page under Property, do the following:
 Select Network Direct Functionality, and then select Enabled
for the Value.
 Select NetworkDirect Technology, and then select iWARP for
the Value.
d. Click OK to save your changes and close the adapter properties.