Users Guide

6–Boot from SAN Configuration
FCoE Boot from SAN
119 AH0054602-00 M
Figure 6-30. System Setup: FCoE General Parameters
4. Return to the FCoE Configuration page.
5. Press ESC, and then select FCoE Target Parameters.
6. Press ENTER.
7. In the FCoE General Parameters Menu, enable Connect to the preferred
FCoE target.
8. Type values for the following parameters (Figure 6-31) for the FCoE target,
and then press ENTER:
 World Wide Port Name Target n
 Boot LUN n
Where the value of n is between 1 and 8, enabling you to configure 8 FCoE
targets.