Users Guide

6–Boot from SAN Configuration
FCoE Boot from SAN
118 AH0054602-00 M
Figure 6-29. System Setup: FCoE Mode Enabled
To configure the FCoE boot parameters:
1. On the Device UEFI HII Main Configuration Page, select FCoE
Configuration, and then press ENTER.
2. On the FCoE Configuration Page, select FCoE General Parameters, and
then press ENTER.
3. On the FCoE General Parameters page (Figure 6-30), press the UP
ARROW and DOWN ARROW keys to select a parameter, and then press
ENTER to select and input the following values:
 Fabric Discovery Retry Count: Default value or as required
 LUN Busy Retry Count: Default value or as required