Users Guide

6–Boot from SAN Configuration
iSCSI Boot from SAN
94 AH0054602-00 M
4. Inject the latest Marvell drivers by mounting drivers in the virtual media:
a. Click Load driver, and then click Browse (see Figure 6-18).
Figure 6-18. Windows Setup: Selecting Driver to Install
b. Navigate to the driver location and choose the qevbd driver.
c. Choose the adapter on which to install the driver, and then click Next
to continue.
5. Repeat Step 4 to load the qeios driver (Marvell L4 iSCSI driver).
6. After injecting the qevbd and qeios drivers, click Next to begin installation on
the iSCSI LUN. Then follow the on-screen instructions.
The server will undergo a reboot multiple times as part of the installation
process, and then will boot up from the iSCSI boot from SAN LUN.
7. If it does not automatically boot, access the Boot Menu and select the
specific port boot entry to boot from the iSCSI LUN.
Configuring iSCSI Boot from SAN on Linux
This section provides iSCSI boot from SAN procedures for the following Linux
distributions:
 Configuring iSCSI Boot from SAN for RHEL 7.5 and Later
 Configuring iSCSI Boot from SAN for SLES 12 SP3 and Later
 Configuring iSCSI Boot from SAN for Other Linux Distributions