Users Guide

6–Boot from SAN Configuration
iSCSI Boot from SAN
79 AH0054602-00 M
8. Select iSCSI First Target Parameters (Figure 6-10), and then press
ENTER.
Figure 6-10. System Setup: Selecting iSCSI First Target Parameters
9. On the iSCSI First Target Parameters page, set the Connect option to
Enabled for the iSCSI target.
10. Type values for the following parameters for the iSCSI target, and then
press ENTER:
 IPv4* Address
 TCP Port
 Boot LUN
 iSCSI Name
 CHAP ID
 CHAP Secret
NOTE
For the preceding parameters with an asterisk (*), the label will change
to IPv6 or IPv4 (default) based on IP version set on the iSCSI General
Parameters page, as shown in Figure 6-11.