Users Guide

6–Boot from SAN Configuration
iSCSI Boot from SAN
78 AH0054602-00 M
Figure 6-9. System Setup: iSCSI Initiator Parameters
7. Return to the iSCSI Configuration page, and then press ESC.
NOTE
For the preceding items with asterisks (*), note the following:
 The label will change to IPv6 or IPv4 (default) based on the IP
version set on the iSCSI General Parameters page (Figure 6-7 on
page 75).
 Carefully enter the IP address. There is no error-checking
performed against the IP address to check for duplicates, incorrect
segment, or network assignment.