Users Guide

17–Regulatory Information
FCC Notice
268 BC0054508-00 M
FCC Notice
FCC, Class B
Marvell BCM57xx and BCM57xxx gigabit Ethernet controller
 BCM95708A0804F
 BCM95709A0907G
 BCM95709A0906G
 BCM957810A1008G
Marvell Semiconductor, Inc.
15485 San Canyon Ave
Irvine, CA 92618 USA
The equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: 1) The device may not cause harmful interference,
and 2) This equipment must accept any interference received, including
interference that may cause unwanted operation.
The equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. The equipment generates, uses and can radiate radio-frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a specific installation. If the equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for assistance.
Do not make mechanical or electrical modifications to the equipment.
NOTE
If the device is changed or modified without permission of Marvell, the user
may void his or her authority to operate the equipment.