Users Guide

13–Fibre Channel Over Ethernet
Configuring FCoE
246 BC0054508-00 M
To enable and disable the FCoE-offload instance on Windows using QCC
GUI:
1. Open QCC GUI.
2. In the tree pane on the left, under the port node, select the port’s virtual bus
device instance.
3. In the configuration pane on the right, click the Resource Config tab.
The Resource Config page appears (see Figure 13-36).
Figure 13-36. Resource Config Page
4. Complete the Ethernet/NDIS and/or iSCSI and/or FCoE and/or TOE settings
on the Resource Config page for each selected port as follows:
a. To enable FCoE offload for the port, for the FCoE parameter, select the
Value check box.
b. To disable FCoE offload for the port, for the FCoE parameter, clear the
Value check box.
c. Click the Apply button.