Users Guide

13–Fibre Channel Over Ethernet
FCoE Boot from SAN
215 BC0054508-00 M
3. Ensure that DCB and DCBX are enabled on the device (Figure 13-3). FCoE
boot is only supported on DCBX-capable configurations. As such, DCB and
DCBX must be enabled, and the directly attached link peer must also be
DCBX-capable with parameters that allow for full DCBX synchronization.
Figure 13-3. CCM Device Hardware Configuration
4. On some platforms, you may need to set the boot protocol through system
BIOS configuration in the integrated devices pane as described in the
preceding.