Users Guide

11–Marvell Teaming Services
Event Log Messages
206 BC0054508-00 M
8 Informational Network controller
configured for 1Gb
half-duplex link.
The adapter has been
manually configured
for the selected line
speed and duplex set-
tings.
No action is required.
9 Informational Network controller
configured for 1Gb
full-duplex link.
The adapter has been
manually configured
for the selected line
speed and duplex set-
tings.
No action is required.
10 Error Unable to register the
interrupt service rou-
tine.
The device driver can-
not install the interrupt
handler.
Reboot the operating
system; remove other
device drivers that
may be sharing the
same IRQ.
11 Error Unable to map I/O
space.
The device driver can-
not allocate mem-
ory-mapped
I/O to access driver
registers.
Remove other adapt-
ers from the system,
reduce the amount of
physical memory
installed, and replace
the adapter.
12 Informational Driver initialized suc-
cessfully.
The driver has suc-
cessfully loaded.
No action is required.
13 Error Driver initialization
failed.
Unspecified failure
during driver initializa-
tion.
Reinstall the driver,
update to a newer
driver, run QLogic
Control Suite diagnos-
tics, or replace the
adapter.
14 Error This driver does not
support this device.
Upgrade to the latest
driver.
The driver does not
recognize the installed
adapter.
Upgrade to a driver
version that supports
this adapter.
15 Error This driver fails initial-
ization because the
system is running out
of memory.
Insufficient system
memory prevented the
initialization of the
driver.
Increase system mem-
ory.
Table 11-10. Virtual Bus Driver (VBD) Event Log Messages (Continued)
Message
Number
Severity Message Cause Corrective Action