Users Guide

3–Fibre Channel Configuration
Running Diagnostics—Fibre Channel Ping and Trace Route
82 BK3254601-00 J
ID Data Link Sync Signal Invalid Diagnostic
Port/Loop Miscompare Failure Loss Loss CRC Status
--------- ---------- ------- -------- --------- --------- ----------
01-0B-01 0 0 0 0 0 Success
Running a Fibre Channel CT Ping from QConvergeConsole VMware Plug-ins
For information about running Fibre Channel CT ping from the
QConvergeConsole VMware vCenter Server Plug-in or QConvergeConsole
VMware vSphere Web Client Plug-in, see the section “Diagnostic Tests—Fibre
Channel Port” in the User’s Guide—QConvergeConsole Plug-ins for VMware
vSphere (part number SN0054677-00).
Fibre Channel Trace Route
To run a Fibre Channel trace route from QConvergeConsole GUI:
1. In the system tree pane on the left, click the Host tab.
2. In the content pane on the right, click the Topology tab.
3. Next to Topology, select the Physical option.
4. In the topology map, right-click the applicable adapter.
5. Select the FC Trace Route option.
6. In the Target Selection dialog box, select the target to run the trace route.
7. Click Trace.
NOTE
The default setting will repeat 10 times with output similar to the preceding
for each pass of the test.