Users Guide

3–Fibre Channel Configuration
Running Diagnostics—Fibre Channel Ping and Trace Route
81 BK3254601-00 J
A caution message appears for the diagnostic CT ping test (Figure 3-31).
Figure 3-31. CT Ping Test Caution
6. Ensure that the port has no active I/O operations, and then either click Yes
to proceed or No to cancel the test.
Running a Fibre Channel CT Ping from QConvergeConsole CLI
To run a Fibre Channel CT ping test from QConvergeConsole CLI:
1. From the QConvergeConsole CLI FC Diagnostics menu, select 7: CT Ping
Test.
2. From the HBA Model list, select the port that you want to ping.
3. From the CT Ping Test menu, select 4: Start Diagnostic Test.
The following shows example output from the CT ping test.
----------------------------------------------
Diagnostics Test Configuration
----------------------------------------------
Diagnostic Mode : CT Ping
Number of tests (1-10000) : 10
Number of Pass : 1
Test Increment (1-10000) : 1
Abort On Error : Ignore
Test Continuous : OFF
---------------------------------------------------