Users Guide

3–Fibre Channel Configuration
Running Diagnostics—Fibre Channel Ping and Trace Route
80 BK3254601-00 J
Running a Fibre Channel CT Ping Test
You can run a Fibre Channel CT ping test from QConvergeConsole GUI,
QConvergeConsole CLI, or the QConvergeConsole VMware plug-ins, as
described in this section.
Running a Fibre Channel CT Ping from QConvergeConsole GUI
To run a Fibre Channel CT ping test from QConvergeConsole GUI:
1. In the QConvergeConsole GUI left pane, click the Host tab.
2. On the Host page, expand the adapter node and then select a port.
3. In the content pane on the right, click the Diagnostics tab.
4. On the Diagnostics page, click the General Diagnostics tab.
5. On the General Diagnostics page (see Figure 3-30), complete the Test
Configuration options, and then click CT Ping Test to start the test.
Figure 3-30. Running the Fibre Channel CT Ping Test