Users Guide

3–Fibre Channel Configuration
Configuring and Verifying FA-BLD
71 BK3254601-00 J
After refreshing the Brocade switch, the Device Port WWN appears in Web Tools
as shown in Figure 3-22.
Figure 3-22. Device Port WWN (Static) for Brocade Switch
Configuring and Verifying FA-BLD
This section provides the following information on fabric-assigned boot LUN
discovery (FA-BLD):
 Configuring FA-BLD from the Adapter
 Verifying that FA-BLD is Operational
 Adapter Side Restrictions
Configuring FA-BLD from the Adapter
On the adapter side, follow these procedures to configure fabric-assigned boot
LUN discovery (FA-BLD) in the QConvergeConsole GUI and QConvergeConsole
CLI.
Enabling Host Bus Adapter Port BIOS and Fabric-assigned Boot LUN with
QConvergeConsole GUI
To enable the Host Bus Adapter Port BIOS:
1. In QConvergeConsole GUI, select the Host tab in the left pane.
2. In the system tree, expand the adapter node and then select a port node.
3. In the content pane on the right, click the Parameters tab.
4. On the Parameters page, click the HBA Parameters tab.
5. On the HBA Parameters page, select the Enable HBA Port BIOS check
box.
6. Click Save.