Users Guide

3–Fibre Channel Configuration
Configuring the UEFI Driver
63 BK3254601-00 J
12. On the Main Configuration Page, select HBA Configuration Page, and then
press ENTER.
The HBA Configuration Page appears; Figure 3-16 shows an example.
Figure 3-16. Dell System Setup: HBA Configuration
13. Use the HBA Configuration Page to configure adapter operational
parameters. In most cases, use the default values.
Table 3-7 describes the fields on the HBA Configuration Page.
Table 3-7. HBA Configuration Page Settings
Setting Description
FC Tape Enable Enables or disables Fibre Channel protocol (FCP-2)
recovery.
Loop Reset Delay Specifies the Fibre Channel arbitrated loop reset delay for
the port. After resetting the loop, the adapter firmware
refrains from initiating any loop activity for the number of
seconds specified. The range is 0 to 60.
Frame Payload Size Specifies the maximum Fibre Channel frame payload size.
Port Login Retry Count Specifies the number of times the adapter firmware initia-
tor tries to log in to a target device port. The range is 0 to
255.