Users Guide

3–Fibre Channel Configuration
Configuring Target Persistent Binding
45 BK3254601-00 J
For more information, refer to the topic about binding target devices in the
QConvergeConsole Help.
Configuring Persistent Binding with Interactive
QConvergeConsole CLI
To bind a target using interactive QConvergeConsole CLI:
1. On the Fibre Channel Adapter Configuration menu, select Target
Persistent Bindings.
2. On the port menu, select a port and then select Bind Target(s) to bind a
target to a port.
3. Select a target and specify a target ID to open the Target Persistent
Binding – FC Port Configuration menu with options to select more targets,
save changes, or cancel the binding operation.
For more information, refer to the section about Fibre Channel interactive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).
Configuring Persistent Binding with Noninteractive
QConvergeConsole CLI
To bind a selected target to a specific adapter using the noninteractive mode of
QConvergeConsole CLI, issue the following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (<target wwnn>
<target wwpn> <target port id> <target id>)
Where:
For more information, refer to the section about Fibre Channel noninteractive
commands in the User’s Guide—QConvergeConsole CLI (part number
SN0054667-00).
hba instance = Adapter number (use the -g command to find)
hba wwnn = Worldwide node name of the adapter
hba wwpn = Worldwide port name of the adapter
target wwnn = Worldwide node name of the target
target wwpn = Worldwide port name of the target
target port id = Port ID of the target
target id = ID to which the target is bound