Users Guide

3–Fibre Channel Configuration
Configuring Target Persistent Binding
44 BK3254601-00 J
Setting Fibre Channel Adapter Parameters with
Noninteractive QConvergeConsole CLI
For information about how to set Fibre Channel adapter parameters using the
noninteractive mode of QConvergeConsole CLI, refer to the section about the
Fibre Channel noninteractive commands in the User’s
Guide—QConvergeConsole CLI (part number SN0054667-00).
Configuring Target Persistent Binding
Use QConvergeConsole to configure target persistent binding:
 Configuring Persistent Binding with QConvergeConsole GUI
 Configuring Persistent Binding with Interactive QConvergeConsole CLI
 Configuring Persistent Binding with Noninteractive QConvergeConsole CLI
Configuring Persistent Binding with QConvergeConsole GUI
To bind target devices attached to an adapter port using QConvergeConsole
GUI:
1. In the system tree, expand a Fibre Channel node.
2. In the system tree for a 2700 Series Adapter, select the physical port
number.
3. Click the Targets tab, and then click the Target Persistent Binding tab.
4. Choose the binding options:
 Select the Bind All check box to bind all the devices listed to adapter
ports.
 Select the Bind check box if you want to configure a specific port and
bind it to the target ID that you have selected from the Target ID list. If
you do not want to configure the port, clear the check box. If you clear
the check box, the corresponding port is unconfigured.
5. To save the configuration changes, click Save.
6. If the Security Check dialog box appears, type the password in the Enter
Password box, and then click OK.
7. The system overwrites any previously saved configuration for the current
adapter and displays a message box. Click OK to close the message box.
NOTE
Target persistent binding is supported only on Windows.