Users Guide

3–Fibre Channel Configuration
Using Fast!UTIL for Custom Configuration
37 BK3254601-00 J
4. A message indicates that the configuration settings have been modified.
Select Save changes.
5. To load the new parameters, reboot the system.
The Fast!UTIL Options menu provides the following options:
 Configuration Settings
 Scan Fibre Devices
 Fibre Disk Utility
 Loopback Data Test
 Select Adapter
 Exit Fast!UTIL
Configuration Settings
The following sections show and describe the 2700 Series Adapters
Configuration Settings menu options in Fast!UTIL:
 Adapter Settings
 Selectable Boot Settings
 Restore Default Settings
 Raw NVRAM Data
 Advanced Adapter Settings
Adapter Settings
Table 3-1 describes the adapter settings.
CAUTION
If the configuration settings are incorrect, your 2700 Series Adapter may not
function properly.
Table 3-1. Adapter Settings
Setting Values Default Description
Host Bus
Adapter BIOS
Enabled,
Disabled
Disabled Disabling this setting disables the ROM BIOS on the 2700
Series Adapter, which frees space in upper memory. If you
are booting from a Fibre Channel disk drive attached to the
2700 Series Adapter, you must enable this setting. See
“Selectable Boot Settings” on page 39 for details on specify-
ing the boot device.