Users Guide

A–Troubleshooting
Troubleshooting with a Diagnostic Port (D_Port)
123 BK3254601-00 J
Test Start time Result EST(HH:MM:SS) Comments
==============================================================================
Electrical loopback 01:46:08 PASSED -------- ----------
Optical loopback 01:46:54 PASSED -------- ----------
Link traffic test -------- SKIPPED -------- ----------
==============================================================================
Roundtrip link latency: 157 nano-seconds
Estimated cable distance: 3 meters
Buffers required: 1 (for 2112 byte frames at 16Gbps speed)s
Verifying D_Port Mode with QConvergeConsole GUI
To verify D_Port mode in QConvergeConsole GUI:
1. In the QConvergeConsole left pane, click the Host tab.
2. On the Host page, expand a 2700 Series Adapter to view its port nodes.
If a port is in D_Port mode, the port node specifies Loop Down, Diagnostic
Mode. Figure A-3 shows an example.
Figure A-3. D_Port Mode in QConvergeConsole GUI