Users Guide

A–Troubleshooting

Troubleshooting with a Diagnostic Port (D_Port)

121 BK3254601-00 J

To disable D_Port diagnostic mode:

From the Brocade Fibre Channel 16G or 32G switch, issue the following

commands:

# portdisable <port_num>

# portcfgdport ––disable <port_num>

# portenable <port_num>

The D_Port test stops.

Configuring and Running Diagnostics Port on a Cisco

Fibre Channel 16 or 32G Switch

The following example configures and starts a diagnostic test on port 2 of a Cisco

Fibre Channel 9396S or 97xx switch (NX-OS 8.2.1 or later). For more details

about the switch, see the Cisco switch documentation.

Cisco# config t

Cisco# int fc 1/2

Cisco(config-if)# shut

Cisco(config-if)# switchport link-diag

Cisco(config-if)# no shut

Cisco(config-if)# diagnostic start interface fc 1/2 test link-diag

To check the diagnostic test status, type the following command:

Cisco(config-if)# show diagnostic result interface fc1/1 test

link-diag

PWWN of peer port: 21:00:00:24:ff:8f:c9:e0

Status: Supported (Reflector)

Reflector loopback capabilities: Xcvr-optical Electrical

Time of Test: Mon Feb 5 16:31:02 2018

Total time taken: 20 seconds

===================|===========|===========|==========|============================|=============

===================|===========|===========|====|=====|=========|=========|========|=============

Remote-Switched(R) | 0| 0| 0| 0| 0| 0| 0| -NA-

Mac(R) | 0| 0| 0| 0| 0| 0| 0| -NA-

Xcvr-optical(R) | 7225275| 7225275| 0| 0| 0| 2112| 1064| Success

Electrical(R) | 20000| 20000| -NA- | -NA- | -NA- | Success

=================================================================================================