Users Guide

3–Fibre Channel Configuration
Configuring End-to-End CS_CTL QoS
92 BK3254601-00 J
6. Set the vPort priority as follows:
 If the vPort is listed under QoS:
a. Select the vPort.
b. Set the QoS priority value for the vPort by moving the
corresponding slider.
c. Click Save.
Figure 3-39 shows an example.
Figure 3-39. Changing vPort Priority Using QConvergeConsole Plug-ins
 If vPort is not listed under QoS:
a. Under QoS, click Add.
b. Set the QoS priority value by moving the corresponding slider.
c. Enter the vPort WWPN.
d. Click Save.
7. Click Refresh to see the new QoS settings.
To remove a vPort priority:
1. Under QoS, locate the vPort whose priority you want to remove.
2. Do one of the following:
 Select the Delete check box of the vPort you want to remove.
 Select the Delete check box in the header to select or clear all of the
vPorts.
3. Click Save.