Install Guide

Table Of Contents

Doc. No. TD-000966 Rev. 1

Preface

This guide describes how to install, uninstall, and start QConvergeConsole

GUI,

a Web-based management tool for configuring and managing QLogic

Fibre

Channel Adapters, FastLinQ Intelligent Ethernet Adapters, and FastLinQ

Converged Network Adapters from Marvell within SANs.

Throughout this guide, the QConvergeConsole GUI management tool is also

referred to as QCC GUI, and the terms target and device are used

interchangeably.

Intended Audience

This guide is for system administrators who are responsible for installing,

configuring, and managing Marvell QLogic adapters using QConvergeConsole

GUI on Windows and Linux hosts.

What Is in This Guide

This user’s guide contains the basic information you need to get started with

QConvergeConsole GUI.

This preface describes the organization of the QConvergeConsole GUI help

system, specifies the intended audience, lists related documents, explains

typographic conventions used in this guide, and provides technical support and

contact information.

The remainder of the user's guide is organized into the following chapters:

 Chapter 1 System Requirements lists the hardware, software, and operating

system requirements that must be met to ensure successful operation of

QConvergeConsole GUI.

 Chapter 2 Installing QConvergeConsole GUI describes how to install and

uninstall QConvergeConsole GUI.

NOTE

In Windows

environments, when you run the QCS CLI and Management

Agents Installer, it will uninstall QLogic Control Suite (QCS) GUI (if installed

on system) and any related components from your system.