Install Guide
Table Of Contents
- Table of Contents
- Preface
- 1 System Requirements
- 2 Installing QConvergeConsole GUI
- Before You Begin
- Downloading and Installing Management Agents
- Installing QConvergeConsole GUI
- Uninstalling QConvergeConsole GUI
- 3 Getting Started
- 4 Security Considerations
- 5 Troubleshooting
- A Revision History
- Glossary
- Index
5–Troubleshooting
Installing QLogic QConvergeConsole Beside SSMC and vPower NFS Service
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 54 Copyright © 2021 Marvell
Figure 5-13. Boot Config Updated Successfully Message
21. Reboot the system.
22. Start the SSMC and VBR Services after reboot.
NOTE
If you provide the correct password, the message, “Boot config
updated successfully, Reboot required” as shown in Figure 5-13.