Install Guide

5–Troubleshooting
Setting a Tomcat Log File
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 42 Copyright © 2021 Marvell
Removing QCC GUI Agents for an Ongoing Hot Swap,
Dynamic Reconfiguration, Suspend or Resume Operation
To remove the QConvergeConsole GUI application for an ongoing hot swap,
suspend, dynamic reconfiguration, or resume operation, issue the following In the
command line:
#pkgrm QLRemote
#pkgrm NQLRemote
Setting a Tomcat Log File
This section explains how to configure Tomcat to direct debug message output
from QConvergeConsole GUI to a specific file location. Refer to the appropriate
procedure for your OS:
 Configure Tomcat on Windows-based Systems
 Configure Tomcat on Linux-based Systems
 Configure Tomcat on Solaris-based Systems
Configure Tomcat on Windows-based Systems
To set a Tomcat log file in Windows:
1. On the Tomcat Program Files menu, click Configure Tomcat, as shown in
Figure 5-1.
Figure 5-1. Tomcat Program Files Menu
NOTE
Marvell highly recommends that you remove the QCC GUI agents during an
ongoing hot swap, dynamic reconfiguration, suspend, and resume
operation.