Install Guide
Table Of Contents
- Table of Contents
- Preface
- 1 System Requirements
- 2 Installing QConvergeConsole GUI
- Before You Begin
- Downloading and Installing Management Agents
- Installing QConvergeConsole GUI
- Uninstalling QConvergeConsole GUI
- 3 Getting Started
- 4 Security Considerations
- 5 Troubleshooting
- A Revision History
- Glossary
- Index
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 41 Copyright © 2021 Marvell
5 Troubleshooting
This chapter lists known issues and describes procedures that may be helpful for
troubleshooting, including:
Recommendations for Solaris Hot Swap, Dynamic Reconfiguration,
Suspend and Resume Operations
Setting a Tomcat Log File
Follow the instructions in this section to set up a log file for troubleshooting.
Installing QLogic QConvergeConsole Beside SSMC and vPower NFS
Service
Recommendations for Solaris Hot Swap, Dynamic
Reconfiguration, Suspend and Resume
Operations
The QConvergeConsole GUI application must be stopped before performing any
hot swap, dynamic reconfiguration, suspend and resume operations in a Solaris
operating system. Use the following procedures as needed.
Stopping the QCC GUI Agents
To stop the QCC GUI, issue the following in the command line:
# ./etc/rc3.d/S99qlremote stop
# ./etc/rc3.d/S99netqlremote stop
Starting the QCC Agents Without Rebooting the Server
To start the QConvergeConsole application without rebooting the server, issue the
following in the command line:
# ./etc/rc3.d/S99qlremote start
# ./etc/rc3.d/S99netqlremote start
NOTE
All QCC-GUI applications will restart after the system is rebooted.