Install Guide

Table Of Contents

2–Installing QConvergeConsole GUI

Installing QConvergeConsole GUI

Doc. No. TD-000966 Rev. 1

6. In the next dialog box, select Yes if you want a localhost-only installation. Or,

if you do not want a localhost-only installation, select No.

7. In the Pre-Installation Summary dialog box, read the information, and then

click Install.

8. (Optional) Complete the following in the Security Login Configuration:

a. Type a value in the Login ID box.

b. Type a value in the Password box.

c. If applicable, select the Check this box to enable Security Login

check box.

d. Click Next.

9. A message box prompts you to confirm if you want to enable the secure

socket layer (SSL) feature, which allows data to be encrypted within a

secure layer before passing it to and from the server:

 Yes - Click to enable the SSL feature.

 No - Click to disable the SSL feature.

10. In the Tomcat SSL Port Number Setup dialog box, type a valid SSL port

number in the range 1025–65536, or accept the default port number, 8443.

Then click Next to continue.

11. In the Install Complete dialog box, click Done to exit the installer.

NOTE

The localhost-only option installs QConvergeConsole GUI locally so

that you must run it locally (a remote connection is not possible). To

disable the option, you must uninstall QCC GUI and then re-install it,

selecting No in this step.

NOTE

See “Starting QConvergeConsole GUI” on page 27 to start

QConvergeConsole GUI