Install Guide

2–Installing QConvergeConsole GUI
Installing QConvergeConsole GUI
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 14 Copyright © 2021 Marvell
To enable the Localhost Only feature on Linux:
1. Edit the /etc/hosts.allow file by adding the following two lines to the
very end of the file:
Line #1: rpcbind: LOCAL, 127.0.0.1, (add any allowable IPs)
Line #2: A blank line (Note: The last line in the file must be blank.)
2. Edit the /etc/hosts.deny file by adding the following two lines to the
very end of the file:
Line #1: rpcbind: ALL
Line #2: A blank line (Note: The last line in the file must be blank.)
Installing QConvergeConsole GUI
Refer to the appropriate installation procedure for your operating system:
 Installing QConvergeConsole GUI in a Windows Environment
 Installing QConvergeConsole GUI in a Linux Environment
 Installing QConvergeConsole GUI in a Solaris Environment
 Installing QConvergeConsole GUI in a Console Window
Installing QConvergeConsole GUI in a Windows Environment
The QConvergeConsole Installer for Windows is a self-extracting utility that
installs QConvergeConsole GUI and related files. Follow the steps in this section
to install QConvergeConsole GUI on a Windows system.
NOTE
Prior to installation, read the items noted in “Before You Begin” on page 7.
NOTE
 For information on firewall configuration on Windows systems, refer to
“Windows Firewall Configuration” on page 35.
 The location of the installed QConvergeConsole files depends on which
QCC GUI version you run, and the operating system on which you install
it, as follows:
 QCC GUI x64 version on a 64-bit Windows operating system:
All QCC files are installed in the folder Program Files.