Install Guide

Table Of Contents

2–Installing QConvergeConsole GUI

Downloading and Installing Management Agents

Doc. No. TD-000966 Rev. 1

Installing the Agents Using the Built-in Agent Installer

To access the Agent Installer within QConvergeConsole GUI:

1. Point to the gear icon , point to Help, and then click Download Agent

Installers.

2. Follow the window prompts.

For detailed installation instructions, refer to the QConvergeConsole GUI

help system. (Point to the gear icon , point to Help, and then click

Browse Contents. In the QConvergeConsole Help window, click the

Search tab, and then search for “agent installer”).

Installing the QLNXRemote Agent

To run the QLNXRemote Install Wizard for Windows x64:

 In Windows Explorer, double-click the following file:

QLNXRemote_xxx-<x.xx.xxxx>\setup.exe

Using the Localhost Only Feature

Note the following regarding the portmap Localhost Only functional behavior:

 On the system where the Localhost Only feature is enabled,

QConvergeConsole GUI can connect only to an IP address that is listed in

the output of the DOS command ipconfig.

 On a system where the portmap setting is enabled for the Localhost Only

feature, you can remotely manage the adapter installed on the system. To

connect remotely, use a URL that can open QConvergeConsole GUI

installed on the system configured for Localhost Only.

 On a Windows system, the portmap Localhost Only feature is supported

only if the QLogic ONC/RPC port-mapper is installed (installed only if the

Windows RPC port-mapper service does not exist).

NOTE

 Be sure to use same installer type for all the agents that you install. For

example, if you use the .pkg installer type for qlremote, you must

also use the .pkg installer type for netqlremote and iqlremote.

Mixing installer types, such as using the .pkg type for qlremote and

the .p5p type for netqlremote, results in an error.

 If an agent is already installed, you must uninstall it before installing a

new version.