Install Guide

2–Installing QConvergeConsole GUI
Downloading and Installing Management Agents
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 8 Copyright © 2021 Marvell
 If upgrading QConvergeConsole GUI from an older version, be sure to clear
the browser cache before installing the new version. See your browser’s
documentation or help for instructions. Additional information can be found
here:
http://kb.iu.edu/data/ahic.html
 If using the default Tomcat port number (8080) will cause a conflict, refer to
“Password Protection for Access Control” on page 33. (You can also
manually specify the Tomcat port number.)
 For information on creating a Tomcat log file for troubleshooting, refer to
“Setting a Tomcat Log File” on page 42.
 To enable access to the adapters on a host server, the management
agents—qlremote (Fibre Channel and FCoE), qlnxremote (FastLinQ),
netqlremote (Ethernet [NIC]), and iqlremote (iSCSI)—must already be
installed on the host. For detailed information on obtaining and installing the
management agents, refer to “Downloading and Installing Management
Agents” on page 8.
Downloading and Installing Management Agents
To manage the adapters on a local or remote host, the management agents (also
called agents) used by the host’s adapters must already be installed on the host.
To connect to a remote host, at least one management agent used by any of the
host’s adapters must be installed and running on the host. Only protocols whose
agents are installed and running are shown under the host’s system tree node.
The management agents include the following:
 netqlremote for Ethernet Networking (NIC)
 qlremote for Fibre Channel and FCoE
 qlnxremote for FastLinQ Adapters
The management agents are not automatically installed by the QCC GUI installer
and must be downloaded and installed separately. You can use the built-in agent
installer (see Installing the Agents Using the Built-in Agent Installer).
This section includes the following information:
 Installing the Agents from Downloads
 Installing the Agents Using the Built-in Agent Installer
 Installing the QLNXRemote Agent
 Using the Localhost Only Feature