Install Guide

Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 7 Copyright © 2021 Marvell
2 Installing
QConvergeConsole GUI
This chapter provides information on downloading, installing, and uninstalling
QConvergeConsole GUI, and downloading, and installing management agents:
 Before You Begin
 “Downloading and Installing Management Agents” on page 8
 “Installing QConvergeConsole GUI” on page 14
 “Uninstalling QConvergeConsole GUI” on page 23
Before You Begin
Before installing QConvergeConsole GUI, note the following:
 Marvell now supports QConvergeConsole GUI as the only GUI management
tool across all adapters. QCS GUI is no longer supported for the 3400
Series Adapters and adapters based on 57xx/57xxx controllers, and has
been replaced by the QConvergeConsole GUI management tool.
QConvergeConsole GUI provides single-pane-of-glass GUI management
for all QLogic adapters.
 In Windows environments, when you run the QCS CLI and Management
Agents Installer, it will uninstall QCS GUI (if installed on the system) and any
related components from your system.
 If you are installing SSMC and NFS along with QConvergeConsole GUI,
ensure that TCP ports 8080, 8443, and 111 are not in use. Doing so ensures
proper installation of QConvergeConsole GUI. For more information, see
“Installing QLogic QConvergeConsole Beside SSMC and vPower NFS
Service” on page 47.
 If using Windows firewalls, refer to “Windows Firewall Configuration” on
page 35 for information on Windows firewall configuration.