Install Guide
Table Of Contents
- Table of Contents
- Preface
- 1 System Requirements
- 2 Installing QConvergeConsole GUI
- Before You Begin
- Downloading and Installing Management Agents
- Installing QConvergeConsole GUI
- Uninstalling QConvergeConsole GUI
- 3 Getting Started
- 4 Security Considerations
- 5 Troubleshooting
- A Revision History
- Glossary
- Index
1–System Requirements
Supported QLogic and FastLinQ Adapters
Doc. No. TD-000966 Rev. 1
January 21, 2021 Page 4 Copyright © 2021 Marvell
Ubuntu
®
Server 18.04, 20.04
Supported QLogic and FastLinQ Adapters
QConvergeConsole GUI supports the following Marvell QLogic-branded adapters.
For support of OEM-branded adapters, contact your OEM.
2500, 2600, and 2700 Series Fibre Channel Adapters
FastLinQ 45000 Series Converged Network Adapters
FastLinQ 45000 Series Intelligent Ethernet Adapters
NOTE
To run QConvergeConsole GUI on Solaris 11.4, you must disable the firewall
by issuing the following command after each boot-up and before running
QCC GUI: netservices open
FastLinQ Adapters (3400/8400/41000/45000 Series) currently do not
support Solaris.
QLE277x Series adapters currently do not support Solaris or Ubuntu.
NOTE
For details on operating system versions, see the QConvergeConsole Read
Me, which you can obtain from the Marvell Web site, www.marvell.com
,
Downloads and Documentation page.
NOTE
For information about Marvell QLogic and FastLinQ adapters, refer to the
Marvell Web site, Products page:
https://www.marvell.com/products/